Iphone 5 repair - Change glass iphone 5s

you rip the cable, installing a new home button will only restore ordinary home button functions, not the Touch ID features. Go slowly and carefully to avoid damage. Otherwise

it may cause severe damage to the LCD during reassembly. Step 3: Battery Connection. Edit Starting under the earpiece speaker contacts, use a plastic opening tool or the tip of a spudger to pry the front facing camera cable out of the display assembly. During reassembly, ensure the contact is in the correct orientationon the side of the screw nearest the LCD. Step 8: Front Camera Assembly, using a case opener tool, carefully remove the front camera assembly. For reassembly, make sure to transfer over the LCD shield, home button, front facing camera assembly, front facing camera lens bezel and earpiece speaker to your new part. Edit Remove the following screws securing the front panel assembly cable bracket to the logic board: One.7 mm Phillips unzoom on iphone 5s #000 screw One.2 mm Phillips #000 screw One.3 mm Phillips #000 screw One more.7 mm Phillips #000 screw This.7 mm screw. Edit Remove the two.6 mm Phillips #000 screws securing the metal battery connector bracket to the logic board. Reinstall the small plastic washer. To avoid stripping the final screw, it may be helpful to first slightly loosen all four screws before removing any. Remove the suction cup from the display assembly. Need a guide for the iPhone 5s screen instead? During reassembly, clip the left-hand hooks under the logic board and lower the bracket towards the outside of the phone. The display is composed of a glass screen and a plastic bezel with metal clips. Edit Press a suction cup onto the screen, just above the home button. Edit Remove the front panel assembly cable bracket from the logic board. Place the home button into the new assembly. Edit Remove the two screws securing the upper component bracket:.0 mm Phillips #000.3 mm Phillips #000 It is imperative that the right screws are inserted into their respective holes. Edit Remove the two.4 mm Phillips #000 screws from the home button bracket. Select a Language: Deutsch, english, español, français, italiano, nederlands, português.

Change glass iphone 5s

First Time Author, edit Lift the display cable bracket toward the battery to unhook. Once the clips have been released on the bottom and sides of the front panel assembly. The aim here is to get the three plastic brackets under the metal frame of the phone and move with slight pressure packup from the sides to the bottom. S too far, you will need to transfer them to the new cable.

Intro: How to, replace Glass, only Screen on Your, iPhone.The phone repair business is booming due to all the cracked screens, why are you not taking the opportunity to make some easy money?

Vad kostar en iphone att tillverka Change glass iphone 5s

The top suction cup should rest just above the home button. However, this holder is essential for the proximity iphone sensor to function correctly. Edit Do not try to completely remove the front panel assembly from the rear case.

Place the suction cup onto the screen near the home button and pull upward just enough so that there is a gap in between the frame and the screen e you case opener tool and work around the gap until it's loose.Regardless of the tool you use, you need to be sure you pull up the entire display.

 

M: replace glass on iphone

Quite a lot actually.It's held in place by some adhesive.Edit Before you proceed, discharge your iPhone battery below.It used to be impossible to separate the glass from the lcd because of the strong bond between the two.”